I'm planning to install a new outlet higher up in the same stud bay as an existing one, which is located down low. My concern is about cutting a hole for the outlet—specifically, will I have a bunch of dense pack cellulose insulation pouring out once I make that cut?
3 Answers
Yeah, a little bit of insulation might fall out when you cut the hole, but it won’t empty the entire cavity or anything like that. You should be fine!
If it's the cellulose type of insulation, you might see a tiny bit fall out, but don't worry, it won't be a huge mess. You shouldn’t have a big problem. Just be prepared for a little fluff!
Just a heads up, someone pointed out that your outlet is installed upside down! Some electricians do this intentionally for half-hot setups, which can be handy for lamps and lighting needs. It's a safety thing too, so just a little insight while you're at it!
It’s also common in commercial work to ensure that the outlet is less likely to cause issues. If you’re switching power, it does make sense!
Yeah, I’ve seen that before. It’s a good practice because if something falls on it, it’ll hit the ground leg first, minimizing the chances of a short circuit! Just thought you might want to know.