Hey everyone! I've got a bit of a situation with my dryer setup. Currently, it's exhausting right into my garage, which I know isn't ideal. I'm looking to change that by rerouting the exhaust. My plan is to run the duct up the garage wall, across to the other side, and then down to let the exhaust out of the house. I've attached a drawing of my current and proposed setups (don't judge my artistic skills!). So, I have two questions: (1) is this rerouting method correct or have any issues I should be aware of? And (2) is this setup compliant with building codes? I'm really keen on doing it right since exhausting directly into the garage is definitely a big no-no.
3 Answers
Going up and over is a bad idea because it can create spots where lint collects, making it hard to clean out. I suggest swinging a 90-degree elbow right through the garage wall toward the nearest exterior wall. Less elbow bends means fewer chances of blockages!
Honestly, I wouldn't bother bringing the exhaust down the wall. Just run it straight out when you reach the crossing point. That way, you avoid unnecessary elbows that could trap lint, which is a big issue.
Thanks! I was worried about aesthetics, but I guess the lint issue is more critical!
If you're using a rigid metal duct, keep in mind the maximum length should be 35 feet total, but you should subtract 5 feet for each elbow in the setup. It's important to minimize bends to reduce lint build-up!
Thanks for that tip!
That makes sense. I appreciate it! Unfortunately, getting to the nearest wall would require navigating several elbows, so your point about lint is valuable!