Hey everyone! I'm looking to replace the factory saw blades on my table saw and miter saw, but I'm feeling a bit lost with all the options out there. I've spent a few hours researching and watching videos, but I still have quite a few questions.
For my table saw (StopSaw Contractor Saw), I'm considering this blade: [CMT Orange Chrome Carbide Thin Kerf 10" Ultimate Crosscutting Blade](https://taytools.com/products/copy-of-cmt-orange-chrome-carbide-thin-kerf-10-ultimate-crosscutting-blade-80-teeth-alternate-top-bevel-grind-0-118-kerf?variant=31687599620183).
And for my miter saw (Makita LS1019L - 10 inch), I'm looking at this blade: [CMT Orange Chrome Carbide Full Kerf 10" Ultimate Crosscutting Blade](https://taytools.com/products/cmt-orange-chrome-carbide-full-kerf-10-ultimate-crosscutting-blade-80-teeth-high-alternate-top-bevel-grind-hiatb-0-126-kerf-283-680-10?_pos=5&_sid=0fff75e20&_ss=r).
Both saws have a 5/8 arbor, which I think is standard? I feel like I might be on the right track, but I could definitely use some advice. Thanks in advance for your help!
2 Answers
Both blades you’re looking at are great for cross cuts, but if you plan on ripping wood on your table saw, you might want to consider getting a ripping blade too. A ripping blade typically has fewer teeth (like in the 20's for a 10" blade) for faster cuts. Alternatively, a combination blade with around 40-50 teeth can be a versatile option for both cross cutting and ripping.
Good question! It mainly comes down to the finish quality. More teeth usually mean a smoother cut but can reduce the cutting speed a bit.
I swap between three different blades depending on the job. I use a 24T ripping blade for hardwoods, an 80T crosscut blade for smoother cuts, and a 40T general-purpose blade for everything else. I really like using CMT blades because they strike a good balance between quality and cost, plus they can be re-sharpened.
Would this blade work for that purpose? [CMT Orange Chrome 10" General Purpose Blade](https://taytools.com/products/cmt-orange-chrome-10-general-purpose-blade-24-teeth-flat-top-grind-0-126-kerf?_pos=27&_sid=17e93bc42&_ss=r) Any reason I'd want to choose 40 teeth over 50 teeth for that? Just for a nicer finish?