I recently tried my hand at lime washing an accent wall in my plaster and lath home. After cleaning the wall thoroughly, I applied a mineral primer and let it dry for 24 hours. I then carefully applied the first coat of lime wash using the recommended 'x' method. It dried nicely, so I waited another 24 hours before applying a second coat. Following the manufacturer's advice, while the second coat was still wet, I used a moistened sponge to feather out some areas to achieve the desired depth. However, the final result was disappointing; the wall looks chalky, and I noticed water spots from drips, even though I wiped them away immediately. I'm looking for any helpful tips to correct these issues or improve the finish. Thanks in advance!
1 Answer
It's totally fine to go for a third coat! Lime wash is meant to be applied in thin layers, so don't hesitate to give it another shot. Just make sure each layer is really thin and let each one dry completely before adding the next, that should help with the chalky look.
Did you see any of the suggestions in the other write-up? Those might provide more context!