Hey everyone! I have some spare 2x4s and I need to drill a perfect 3-inch hole through one that's 2 inches thick. I've tried using a hole saw, but it doesn't seem deep enough to go all the way through from just one side. Any recommendations on how to get this done without too much hassle?
3 Answers
You can either drill from both sides and meet in the middle, or you could splurge on a deeper hole saw if you're looking for a one-side solution.
You could use a hole saw to drill until the center bit pokes through the other side, then flip it over and finish the hole with the hole saw from there. It's a pretty straightforward solution!
If you want a really clean hole, a 3-inch forstner bit is a good choice since it can reach the depth you need without any issues. Just make sure it fits your drill properly!
Is there a way to do this without having to drill from both sides?