Hey everyone! I'm wondering if it's possible to attach a larger bearing to the end of a flush trim router bit. I'm trying to route a 1/2" profile around an object, and I want to use that object as the guide for the bearing on the outside. It's a bit tricky to explain, but any advice would be greatly appreciated!
3 Answers
Absolutely, you can swap the bearing from a rabbet set onto your flush trim bit. This allows for a consistent overhang while routing! Just make sure the diameter matches your routing needs.
Here's a rabbet bit kit that comes with different bearings: https://www.amazon.com/FivePears-Rabbet-Router-Bit-Bearings/dp/B0C3HDMG7B. The hole size should match the flush trim bit, but different manufacturers may vary. If you're ordering the bit and the kit, just make sure they match!
Yeah, there are various sizes of bearings available for flush trim bits. You might need to check your local hardware store or online to find the specific size you need. Just keeping the right fit is key!