I just got my hands on a DCD1007 drill today, and while I haven't had a chance to really put it to the test yet, I wanted to get a feel for the clutch settings before I start working on anything important. I did some quick tests using screws and a scrap piece of wood, and I'm a bit confused by the results. Here's what I found:
- When I set it to Setting 1, the screw stops halfway, which seems fine.
- In Setting 2, the screw is flush with the wood—still alright, I guess.
- But then in Setting 3, the screw goes straight through the wood like it's nothing but air! Once the head is almost out, it just spins freely.
This seems a bit off, and I'm wondering if this is how it's supposed to work or if I've got a problem with my clutch. Are the rest of the settings even necessary at this point? Can anyone share their experiences with this model?
2 Answers
That sounds pretty typical for a drill; the clutch is designed to prevent overdriving screws. If it's spinning after the head comes through, it's likely just exceeding the torque threshold rather than a defect. Try using it on different materials and adjusting the settings accordingly. It takes a little practice to find the right balance, but you'll get the hang of it!
It sounds like you're mainly dealing with the clutch settings. You mentioned using speeds 1 and 2 without it clutching out, which makes sense since those provide higher torque. In your case with Setting 3, it's pretty common for the clutch to slip if it's set too high for the job. You might want to dial it back a notch or two when working with softer materials. Just experiment a bit more to find your sweet spot!
Yeah, I totally agree with ToolTimeTerry. I had a similar issue at first, but once I got used to adjusting the settings, it was fine. Just make sure you’re not forcing it too much, and you'll get it right!