How Can I Make Backing Boards for Bookbinding?
Asked by User7345!@#
I'm really getting into bookbinding and I need some backing boards for my projects. These boards are basically two flat slabs that are slightly inclined, and I'm a bit lost on how to create that slope on the wood. Do you think I could use a table or miter saw to achieve that angle, or is there a better tool for the job?
Answers
I’d recommend using a thickness planer. Attach the boards securely to a flat base and shim one side to the angle you want. Just make sure it’s fastened really well since only part of the board will touch the base. You might want to lock a stop at the back end and use hot glue for extra hold.
Reply to this answer
If you're starting with flat stock, you could actually taper the boards before gluing them up. But if you already have the flat parts, a jig for a planer or drum sander should work just fine to get that slope you need.
Reply to this answer
I'd say a bandsaw might be your best bet here, especially with a tilting table. A table saw can be tricky for that depth, and it's not as simple as just flipping the wood over. For finishing, you might find using a hand plane or a belt sander easier in the long run. Good luck!
Reply to this answer
Add your answer
Answers are reviewed before publication.