I'm trying to craft a cabinet scraper similar to the Stanley models 80 or 81 using wood. I want to make the blade from a piece of bandsaw blade which is 27mm high with saw teeth. While I've heard that these blades work well for card scrapers, I'm wondering if they would also perform effectively for a cabinet scraper. Additionally, could someone provide the dimensions of the Stanley 80 and the angle at which the blade is set?
3 Answers
The blade in my Stanley 80 is much thicker than a card scraper - about 1.2mm. It’s ground at a 45-degree angle, which is probably why it works effectively. If you find the bandsaw blade doesn’t work as intended, don’t hesitate to switch it out for a thicker one in the same body. Just keep experimenting and you’ll find the right setup!
For dimensions, I can give you some rough ideas. The highest part of the casting is about 47mm above the sole, with a 75mm wide mouth and a 6mm opening. The blade is around 75mm wide, 600mm deep, and 1.2mm thick. Just a heads up, your bandsaw blade is thinner and narrower than the original design, which might cause some issues with flexing instead of bending properly. Good luck with your project!
If you’re making a wooden version of this scraper, you might have better luck checking out gun-related forums. They often discuss wooden scrapers used for gun stocks. Also, if you’re looking for dimensions, I have a Stanley 80 that I could measure for you!