Hey everyone! I have this pretty intricate 3D design made from putty on my wall, and I'm finding it really tough to scrape off. It's about 1 square foot in size. I'm hoping to find a method that requires low effort and creates minimal dust. Any tips you can share?
1 Answer
There's really no magic fix for this. Your best bet is to either scrape it off or cut out the section of the wall where the design is and then patch it up later. It might sound rough, but it could save you time in the long run if scraping is too tedious.
Cutting it out with a utility knife sounds like a solid idea! I’d rather replace that section than spend days scraping it off. I’ll give it a shot, thanks!