How to Fix a Cloudy Finish After Polyurethane?
I recently applied a water-based polyurethane, but I noticed some small bumps on the final coat, likely from dust. After sanding it down with 3000 grit sandpaper, the…
finishing
Tips for Preventing Ebony Dust from Staining Maple When Making a Chessboard
I'm working on a special project with my wife—an ebony and maple chessboard for her father's birthday, and we're really enjoying the ebony wood. However, I've come across…
How Long Can I Wait Between Coats of Danish Oil?
I'm applying Danish oil to some oak furniture, and the instructions say to apply three coats with 6 hours in between each coat. However, I had to leave…
Is Planing a Better Option Than Sanding for Woodworking Projects?
I've been working on my first real woodworking project—building a set of engineering drawers—and I've been using a block plane that I restored alongside sanding to prepare the…
What Are the Best Wood Polishing Pads to Use?
Hey everyone! I recently watched a video where a guy was polishing his woodworking project with these cool polishing pads instead of traditional sandpaper. He mentioned that they…
Can I Use a Spray Gun for Water-Based Polyurethane?
I'm curious if I can use a spray gun to apply water-based polyurethane, or if I need to stick to applying it by hand. Any tips or advice…
Best Wood for a Picnic Table in Iowa? Finishing Tips Needed!
I'm planning to build a picnic table using a metal kit I found for about $60. I have a couple of wood options in mind: green treated 2x6…
Struggling with Finishing in the Bedroom? Tips Wanted!
I've made good progress with my building skills, but when it comes to finishing projects in the bedroom, I feel stuck. No matter how hard I try, I…
Is it Safe to Thin Polyurethane More Than Recommended?
I've got a quick question about thinning polyurethane. I use a two-component polyurethane that consists of a base and a hardener. The can states that I should dilute…
Should I Cut Plywood Before or After Veneering it?
I'm building a shoe rack with lift-up doors, and I've got the cabinet built. For the top, I'm planning to use a single 10' piece of plywood, cutting…
What’s the Best Way to Remove Sanding Dust from Wood Before Finishing?
I've tried a bunch of methods over the years to clean sanding dust off wood before I apply stain, sealers, or finishes, but I'm looking for some fresh…
How to Properly Sand and Finish Wood with Shellac?
I've been working on a woodworking project where I sanded my piece to 220 grit and applied Bullseye shellac. After sanding again at 220, I followed the instructions…
What's the best way to finish the end of my chair railing?
I just installed a chair railing, but I wasn't expecting it to look so unfinished at the end. I'm looking for suggestions on how to create an end-cap…
Should I Use Mineral Spirits After Sanding Teak?
Hey everyone, I'm looking for clarity on using mineral spirits (or white spirit, as we call it in Norway) after sanding a teak wood table top. I keep…
How Can I Smooth Out Reclaimed Barnwood Without Losing Its Character?
I recently got my hands on some beautiful reclaimed barnwood for a project, but it's quite rough to the touch. I'm looking to achieve a smoother finish while…
How Often Should I Reapply Hardwax Oil to My Walnut Desk?
I have a walnut desk finished with Osmo hardwax oil that I purchased about a year ago. From what I've gathered, it's recommended to reapply the oil yearly…