Hey everyone! I hope this is the right place to ask. I have an old compressor freezer that I've taken the compressor out of, and I'm looking to repurpose the shell into a humidor or curing chamber. My plan is to remove the shelves from the door and install a peltier thermoelectric cooler. Then, I'll place a small humidifier and dehumidifier at the bottom of the freezer. The idea is to connect all of these components to a Niwa device to manage everything.
I'm a bit stuck on whether the size of the thermoelectric cooler will be adequate to manage a space of about 6 square feet and keep it at around 60°F. If it's not enough, I'd appreciate any suggestions for the correct size. Also, based on the components listed, should I be concerned about exceeding the thresholds that the Niwa can handle? Any guidance would be super helpful—thanks in advance!
2 Answers
I say go for it! Just make sure to monitor the humidity and temperature closely, especially since you're using a thermoelectric cooler. They can be a bit tricky when managing larger spaces. Experiment a little, and you’ll find the right balance!
Sounds like a cool project! I think the thermoelectric cooler you listed should be able to handle that size, but keep in mind that cooling efficiency can vary based on a few factors—like insulation and ambient temperature. As for the Niwa, check its maximum load capacity against your components to make sure you’re within limits. It’s good to err on the side of caution! Good luck!
Yeah, definitely keep an eye on how the setup holds up temperature-wise once it’s running. You might have to tweak things for optimal performance.
Thanks! I’ll definitely keep an eye on everything while it’s running. Appreciate the encouragement!